Argaeus Posted December 6, 2019 Share Posted December 6, 2019 Hi @Marten@Stairport, Is there a specific reason why I am getting duplicated coordinates for a single item when trying to add DG? Here are 2 screenshots to show the problem. v2.0.1 Regards. Link to comment Share on other sites More sharing options...
Marten@Stairport Posted December 6, 2019 Share Posted December 6, 2019 Did you reload the scenery after changing it in WED? Link to comment Share on other sites More sharing options...
Argaeus Posted December 6, 2019 Author Share Posted December 6, 2019 I forgot how many times this had happened today I always re-start X-Plane to avoid hick-ups. I do not use "re-load" function too much. Link to comment Share on other sites More sharing options...
Marten@Stairport Posted December 7, 2019 Share Posted December 7, 2019 There are generally only two reasons where that happens and they haben been around from version 1.0.0 on: 1. You reload a scenery after changing it in WED. SAM does check all objects on reload but doesn't delete object positions from cache if the actual object is not present anymore. Therefore a restart is recommended. 2. You configure an object in SAM, then change the object position and delete the configuration after reload. Same like above the old object positions won't be loaded. In a normal workflow that doesn't happen: finish your scenery or at least the ground layout, place Marshaller and finally configure it. If you really have to move an object afterwards make sure to delete the configuration in SAM for that specific object FIRST, then close XPlane and then move the object. 1 Link to comment Share on other sites More sharing options...
Argaeus Posted December 13, 2019 Author Share Posted December 13, 2019 Will keep these in mind. Item 1 seems to be the case for me. Link to comment Share on other sites More sharing options...
Recommended Posts