ItamarMazor Posted July 4, 2021 Share Posted July 4, 2021 @Marten@Stairport the xml file for the Zibo 737 is still incorrect, the y value is way too low, making many SAM jetways incompatible (out of range). It's an easy fix in the file but most people don't know so get problems. Something you could perhaps fix in the next release? y value should be just above 0 on the Zibo. Link to comment Share on other sites More sharing options...
Marten@Stairport Posted July 7, 2021 Share Posted July 7, 2021 @ItamarMazor Hm that doesn't make sense at all. If we set z=0 the door location would be right at the middle of the aircraft and not in the front where the actual door is. Link to comment Share on other sites More sharing options...
ItamarMazor Posted July 8, 2021 Author Share Posted July 8, 2021 (edited) @Marten@Stairport not the Z, the Y. Haven't touched the Z... Just compare the 737-800x /737800x-4K values with the default 737 values. The Y value is positive in the default and quite far negative in the Zibo file. That is why it won't connect in most places. When doing a force connect at that value the jetbridge is actually at the bottom part of the fuselage. Moving the Y value to about (+)0.0500000 fixes this. Edited July 8, 2021 by ItamarMazor 1 Link to comment Share on other sites More sharing options...
Marten@Stairport Posted July 17, 2021 Share Posted July 17, 2021 Confirmed, will be updated in SAM3 next. Link to comment Share on other sites More sharing options...
ItamarMazor Posted July 19, 2021 Author Share Posted July 19, 2021 thank you Link to comment Share on other sites More sharing options...
Recommended Posts