About This File
SmartCopilot Config File for the AFM OVIII
Here is my Smart Copilot Config file for the AFM OVIII Currently Requires Testing But I think Im pretty Close!!
What is Should Synced
-
Pilot & Copilot
- Every Switch & Circuit breaker
- Both GN1000 Panels
- Annunciation Panel
- Autopilot (Please Test this)
- Xplane Failures
- Circuit Breakers Popping
-
Pilot Only (Who Has Control)
- Flight Controls (if it can alter the Speed and Attitude Directly)
- Cabin Heating
- Alternate Air Sources
- Static Objects (Pilots Responsibility to remove Covers Etc)
-
Master
- Fuel Quantity
- TKS Quantity
- Engine Fuel Flow
- Current Time of Day
- Weather
The Basic Setup :
The config file is set to refresh the weather every 2 hours NOAA where X-plane gets its weather is only updated every hour at 10 past the hour. Personally I would set the same in Xplane.
Both set the aircraft same location (including Gate) Cold and dark cockpit (All Switches off)
Master initializes the connection the time of day and weather will be sent as soon as your connected (give it a couple of seconds to update) you should then be good to go!!
Just to stop any problems I would recharge the batteries, refill the oxygen and TKS prior to Connection.
Again please comment on any bugs you find And Enjoy!!!